Hammered dulcimer

Infobox instrument
name=Hammered Dulcimer
names=Dulcimer, Hammer Dulcimer, Four-Hammer Dulcimer, it: Salterio

image_capt=Diatonic hammered dulcimer
classification=Percussion instrument (Chordophone), String instrument

The hammered dulcimer is a stringed musical instrument with the strings stretched over a trapezoidal sounding board. Typically, the dulcimer is set on a stand, at an angle, before the musician, who holds small mallet hammers in each hand to strike the strings (cf. Appalachian dulcimer). The word "dulcimer" is Graeco-Roman, meaning "sweet song", it derives from the Latin "dulcis" (sweet) and the Greek "melos" (song). The dulcimer's origin is uncertain, but tradition holds it was invented in Iran (Persia) some 2000 years ago, where it is called a santur (cf. the folkloric Kashmiri santoor).

The instrument has been revived in the U.S. in the American folk music traditions. Some rock bands employ the hammered dulcimer as a primary instrument, including Macha of Athens, Ga., and Tulsa Drone of Richmond, Va. The dulcimer is played in Wales, East Anglia, Northumbria, Southwest Asia, China, and parts of Southeast Asia, and in traditional Austrian and Bavarian folk music.

trings and tuning

The hammered dulcimer comes in various sizes, identified by the number of strings that cross each of the bridges. A 15/14, for example, has two bridges ("treble" and "bass") and spans three octaves. The strings of a hammered dulcimer are usually found in pairs, two strings for each note (though some instruments have three or four strings per note). Each set of strings is tuned in unison and is called a course. As with a piano, the purpose of using multiple strings per course is to make the instrument louder, although as the courses are rarely in perfect unison, a chorus effect usually results. A hammered dulcimer, like an autoharp, harp, or piano, requires a tuning wrench for tuning, since the dulcimer's strings are wound around tuning pins with square heads. (Ordinarily, 5 mm "zither pins" are used, similar to, but smaller in diameter than piano tuning pins, which come in various sizes ranging upwards from "1/0" or 7 mm.)

The strings of the hammered dulcimer are often tuned diatonically, according to a circle of fifths pattern. Typically, the lowest note (often a G or D) is found on the lower right-hand corner of the instrument, just to the left of the right-hand (bass) bridge. As a player strikes the courses above in sequence, they ascend the diatonic scale based on the G or D. With this tuning, the scale is broken into two tetrachords, or groups of four notes. For example, on an instrument with D as the lowest note, the D major scale is played starting in the lower-right corner and ascending the bass bridge: D - E - F# - G. This is the lower tetrachord of the D major scale. At this point the player returns to the bottom of the instrument and shifts to the treble bridge to play the higher tetrachord: A - B - C# - D.

This shift to the adjacent bridge is required because the bass bridge's fourth string G is the start of the lower tetrachord of the G scale. If the player ascends the first eight strings of the bass bridge, they will encounter a flatted seventh (C natural in this case), because this note is drawn from the G tetrachord. This D major scale with a flatted seventh is the mixolydian mode in D.

The pattern continues to the top of the instrument and to the left-hand side of the treble bridge. Moving from the left side of the bass bridge to the right side of the treble bridge is analogous to moving from the right side of the treble bridge to the left side of the treble bridge.

This diatonically-based tuning results in most, but not all, notes of the chromatic scale being available in each key. To fill in the gaps, many modern dulcimer builders include extra short bridges at the top and bottom of the soundboard, where extra strings are tuned to some or all of the missing pitches. Such instruments are often called "chromatic dulcimers" as opposed to the more traditional "diatonic dulcimers".

Hammered dulcimers of non-European descent may have other tuning patterns, and builders of European-style dulcimers sometimes experiment with alternate tuning patterns.


The hammered dulcimer derives its name from the small mallets that players use to strike the strings, called "hammers". Hammers are usually made of wood (most likely hard woods such as maple, cherry, padauk, oak, walnut, or any other hard wood), but can also be made from any material, including metal and plastic. In the Western hemisphere, hammers are usually stiff, but in Asia, flexible hammers are often used. The head of the hammer can be left bare for a sharp attack sound, or can be covered with adhesive tape, leather, or fabric for a softer sound. Two-sided hammers are also available. The heads of two sided hammers are usually oval or round. Most of the time, one side is left as bare wood while the other side may be covered in leather or a softer material such as piano felt.

Several traditional players have used hammers that differ substantially from those in common use today. Paul Van Arsdale (b. 1920), a player from upstate New York, uses flexible hammers made from hacksaw blades, with leather-covered wooden blocks attached to the ends (these are modeled after the hammers used by his grandfather, Jesse Martin). The Irish player John Rea (1915-1983) used hammers made of thick steel wire, wound with wool. He made these himself from old bicycle spokes. Billy Bennington (1900-1986), a player from Norfolk county in England, used cane hammers bound with wool.

The hammered dulcimer (as well as the mountain dulcimer), can also be bowed, though this is not a widespread practice, as a traditional bow would do little good. In order to make bowing the instrument possible, bowhammers, and more recently Jimbows, were created. Bowhammers are a unique invention used by musician Michael Masley. Jimbows consist of a wooden handle connected to a curved nylon rod, which when rosined, will produce the desired sound.

Four-hammer dulcimer

The four-hammer dulcimer, although a fresh innovation premiering in the early 1990s, is by no means a new instrument. The hammered dulcimer, not to be confused with the mountain dulcimer, has been around for millennia. The four-hammer dulcimer is the same instrument played with special hammers and technique.

The first record of a four-hammer dulcimer is Glenn McClure's variation of the Burton grip. McClure's hammers are wooden dowels with teardrop-shaped heads. One hammer is held between the pad of the thumb and the midsection of the forefinger. The handle of the second hammer is a 2.5cm square pad, which is gripped in the middle and ring fingers. Swiss player Barbara Schirmer is another practitioner of the four-hammer technique.

Another hammer design is two standard flat-handled hammers riveted together about 4cm from the base so they can pivot. As of yet, no technique has been developed for these hammers.

The most recent innovation in four-hammer dulcimer playing is the clip-on hammer, designed by Hasso Pape (HAH-soh PAH-pee) in 2006. The clip on hammer is a wooden dowel with an elliptical spheroid head, similar to the McClure hammers. One hammer is strapped to the farthest section of each of the index and middle fingers by a 1.5cm strip of elastic adjustable by Velcro. Strings are struck in a finger motion similar to that of piano playing.Fact|date=March 2007

Hammered dulcimers around the world

Versions of the hammered dulcimer are used throughout the world. In Eastern Europe, a larger descendant of the hammered dulcimer called the cimbalom is played and has been used by a number of classical composers, including Zoltán Kodály, Igor Stravinsky and Pierre Boulez, and more recently, in a different musical context, by Blue Man Group. The khim is the name of both the Thai and the Khmer hammered dulcimer. The Chinese yangqin is a type of hammered dulcimer that originated in Persia. The santur and santoor are found in the Middle East and India, respectively.

Names for the hammered dulcimer in different countries

* Austria - hackbrett
* Belarus - Цымбалы (tsymbaly)
* Belgium - Hakkebord
* Brazil - saltério
* Cambodia - khim
* China - yangqin
* Croatian - cimbal, cimbale
* Czech Republic - cimbál
* Denmark - hakkebræt
* France - tympanon
* Germany - Hackbrett
* Greece - santouri
* Hungary - cimbalom
* India - santoor
* Iran - santur
* Ireland - tiompan
* Italy - salterio
* Korea - yanggeum 양금
* Laos - khim
* Latgalia - cymbala
* Latvia - cimbole
* Lithuania - cimbalai, cimbolai
* Mexico - salterio
* Mongolia joochin
* Netherlands - hakkebord
* Poland - cymbały tsymbaly
* Portugal - saltério
* Romania - ţambal
* Russia - Цимбалы tsymbaly, Дульцимер (dultsimer)
* Slovakia - cimbal
* Slovenia - cimbale, oprekelj
* Spain - salterio
* Sweden - hackbräda, hammarharpa
* Switzerland - Hackbrett
* Thailand - khim
* Turkey - santur
* Ukraine - Цимбали tsymbaly
* United Kingdom - hammered dulcimer
* United States - hammered dulcimer
* Vietnam - đàn tam thập lục (lit. "36 strings")
* Yiddish - tsimbl

See also

* List of hammered dulcimer players
* List of hammered dulcimer builders

Further reading

* Gifford, Paul M. (2001), "The Hammered Dulcimer: A History", The Scarecrow Press, Inc. ISBN 0-8108-3943-1. A comprehensive history of the hammered dulcimer and its variants.
* Kettlewell, David (1976), "The Dulcimer", PhD thesis. History and playing traditions around the world; web-version at http://www.new-renaissance.net/dulcimer.

External links

* [http://nay-nava.blogfa.com/post-2.aspx Santur] on "Nay-Nava", the encyclopedia of Persian music instruments
* [http://www.dulcimers.org/ Hammered Dulcimer Information]
* [http://www.boldersounds.com/Product.aspx?PID=25 Hammered Dulcimer Sample Library & MP3 Demos]
* [http://www.tsimbl.com/ Klezmer Tsimbl (Related to the Hammered Dulcimer)]
* [http://www.si.edu/resource/faq/nmah/hdhist.htm Smithsonian Institution booklet on hammered dulcimer history and playing]
* [http://www.si.edu/resource/faq/nmah/hdmake.htm Smithsonian Institution booklet on making a hammered dulcimer (by Sam Rizzetta)]

Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Hammered Dulcimer — Le hammered dulcimer est un instrument de musique à cordes frappées à distinguer du dulcimer des Appalaches, qui est un instrument à cordes pincées, cousin de l’épinette des Vosges. Issu du santûr perse, ayant transité en Europe sous le nom de… …   Wikipédia en Français

  • hammered dulcimer — n. DULCIMER (n. 1) * * * …   Universalium

  • hammered dulcimer — n. DULCIMER (n. 1) …   English World dictionary

  • Hammered Dulcimer —   [englisch/amerikanisch, hæməd dʌlsɪme(r)], Hackbrett …   Universal-Lexikon

  • Hammered Dulcimer — Hackbrett nach Virdung 1511 Ein diatonisches Hackbrett …   Deutsch Wikipedia

  • Hammered dulcimer — Le hammered dulcimer est un instrument de musique à cordes frappées à distinguer du dulcimer des Appalaches, qui est un instrument à cordes pincées, cousin de l’épinette des Vosges. Issu du santûr perse, ayant transité en Europe sous le nom de… …   Wikipédia en Français

  • hammered dulcimer — noun see hammer dulcimer …   New Collegiate Dictionary

  • hammered dulcimer — noun a trapezoidal zither with numerous metal strings that are struck with a pair of beaters …   Wiktionary

  • List of hammered dulcimer builders — Noted builders and manufacturers who specialize in hammered dulcimers include:* Gillian Alcock * Michael Allen – Cloud Nine * Joe Bedard * Nick Blanton * Russell Cook Master Works * Ardie Davis * Dusty Strings * Folkcraft Instruments * Rick Fogel …   Wikipedia

  • List of hammered dulcimer players — Noted musicians who play the hammered dulcimer include: A* Matthew Abelson * Azam AliB* Billy Bennington * Korki Buchek * Basia Bulat * Tarun Bhattacharya * Blue Man GroupC* Dave Cousins * Evan Carawan * Guy Carawan * Mitzie Collins * Russell… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.