Free convective layer

In atmospheric sciences, the free convective layer (FCL) is the layer of conditional or potential instability in the troposphere. It is a layer of positive buoyancy (PBE) and is the layer where deep, moist convection (DMC) can occur. On an atmospheric sounding, it is the layer between the level of free convection (LFC) and the equilibrium level (EL). The FCL is important to a variety of convective processes and to severe thunderstorm forecasting.

It is the layer of instability, the "positive area" on thermodynamic diagrams where an ascending air parcel is warmer than its environment. Integrating buoyant energy from the LFC to the EL gives the convective available potential energy (CAPE), an estimate of the maximum energy available to convection. The depth of the FCL is expressed by the formula:

: FCL = ZEL - ZLFC or : FCL = PEL - PLFC

Deep, moist convection is essentially a thunderstorm, it is cumulus congestus clouds or cumulonimbus clouds. An air parcel ascending from the near surface layer (mixed layer or boundary layer) must work through the stable layer of convective inhibition (CIN) when present. This work comes from increasing instability in the low levels by raising the temperature or dew point, or by mechanical lift. Without the aid of mechanical forcing, a parcel must reach its convective temperature (Tc) before moist convection (cloud) begins near the convective condensation level (CCL}, whereas with dynamic lift, cloud base begins near the lifted condensation level (LCL). This will remain as shallow, moist convection (small cumulus clouds) until breaking through the convective inhibition layer, after which DMC ensues as a parcel hits the LFC and enters the FCL, if thermal or mechanical forcing continues. At the level of neutral buoyancy (the EL), a parcel is cooler than the environment and is stable, so it slow down, eventually ceasing at the maximum parcel level (MPL).

References

* Blanchard, David O. (Sep 1998). Assessing the Vertical Distribution of Convective Available Potential Energy. "Weather and Forecasting", 13 (3): 870–877.

See also

* Atmospheric thermodynamics
* Mixed layer

External links

* [http://www.crh.noaa.gov/lsx/science/pdfppt/convective_indices.pdf Atmospheric indices] (National Weather Service St. Louis)


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Convective available potential energy — A skew T plot showing a morning sounding with a large hydrolapse followed by an afternoon sounding showing the cooling which occurred in the mid levels resulting in an unstable atmosphere as surface parcels have now become negatively buoyant. The …   Wikipedia

  • Convective inhibition — A Skew T diagram with important features labeled Convective inhibition (CIN or CINH) is a numerical measure in meteorology that indicates the amount of energy that will prevent an air parcel from rising from the surface to the level of free… …   Wikipedia

  • Convective heat transfer — See also: Heat transfer and convection This figure shows a calculation for thermal convection. Colors closer to red are hot areas and colors closer to blue are cold areas. In this figure, a hot, less dense lower boundary layer sends plumes… …   Wikipedia

  • Level of free convection — The level of free convection (LFC) is the altitude in the atmosphere where the temperature of the environment decreases faster than the moist adiabatic lapse rate of a saturated air parcel at the same level.The usual way of finding the LFC is to… …   Wikipedia

  • Planetary boundary layer — Depiction of where the planetary boundary layer lies on a sunny day The planetary boundary layer (PBL), also known as the atmospheric boundary layer (ABL), is the lowest part of the atmosphere and its behavior is directly influenced by its… …   Wikipedia

  • Mixed layer — The oceanic or limnological mixed layer is a layer in which active turbulence has homogenized some range of depths. The surface mixed layer is a layer where this turbulence is generated by winds, cooling, or processes such as evaporation or sea… …   Wikipedia

  • Atmospheric convection — Conditions favorable for thunderstorm types and complexes Atmospheric convection is the result of a parcel environment instability, or temperature difference, layer in the atmosphere. Different lapse rates within dry and moist air lead to… …   Wikipedia

  • Lapse rate — The lapse rate is defined as the rate of decrease with height for an atmospheric variable. The variable involved is temperature unless specified otherwise.[1][2] The terminology arises from the word lapse in the sense of a decrease or decline;… …   Wikipedia

  • Maximum parcel level — The maximum parcel level (MPL) is the highest level in the atmosphere that a moist convectively rising air parcel will reach after ascending through the free convective layer (FCL) and reaching the equilibrium level (EL), near the tropopause. As… …   Wikipedia

  • Air parcel — An air parcel is an imaginary volume of air used by meteorologists to conceptualize the thermodynamic fluid motions of the atmosphere for use in weather forecasting. For mathematical simplicity, an air parcel is usually considered a rigid cube… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.