Pump-action

A pump-action rifle or shotgun is one in which the handgrip can be pumped back and forth in order to eject and chamber a round of ammunition. It is much faster than a bolt-action and somewhat faster than a lever-action, as it does not require the trigger hand to be removed from the trigger whilst reloading. When used in rifles, this action is also commonly called a slide action.

The term pump-action can also be applied to various airsoft guns and air guns, which use a similar mechanism to both load a pellet and compress a spring piston for power, or pneumatic guns where a pump is used to compress the air used for power. See the airgun article for information on how spring piston and pneumatic airguns work.

Advantages

The speed of cycling of a pump-action, while less than that of an semi-automatic design, is still quite fast. The manual operation gives a pump-action the ability to cycle rounds of widely varying power that a gas or recoil operated firearm would fail to cycle, such as most less than lethal rounds. The simplicity of the pump-action relative to a semi-automatic design also leads to improved durability and lower cost. It has also been noticed that the time taken to work the action allows the operator to identify and aim on a new target, avoiding a "spray and pray" usage.

Layout

A pump-action firearm is typically fed from a tubular magazine underneath the barrel, which also serves as a guide to the movable forend, although some, notably the Remington 760 rifle and its successors, use detachable box magazines. The rounds are fed in one by one through a port in the receiver, where they are pushed forward. A latch at the rear of the magazine holds the rounds in place in the magazine until they are needed. If it is desired to load the gun fully, a round may be loaded through the ejection port directly into the chamber, or cycled from the magazine, which is then topped off with another round. Pump shotguns with detachable box magazines or even drums exist, and may or may not allow the magazine to be inserted without stripping the top round.

Operating cycle

Nearly all pump-actions use a back-and-forward motion of the forend to cycle the action. The forend is connected to the bolt by one or two bars; two bars is considered better because it provides symmetric forces on the bolt and pump and reduces the chances of binding. The motion of the bolt back and forth in a tubular magazine model will also operate the "elevator", which lifts the shells from the level of the magazine to the level of the barrel.

After firing a round, the bolt is unlocked and the forend is free to move. The shooter pulls back on the forend to begin the operating cycle. The bolt unlocks and begins to move to the rear, which extracts and ejects the empty shell from the chamber, cocks the hammer, and begins to load the new shell. In a tubular magazine design, as the bolt moves rearwards, a single shell is released from the magazine, and is pushed backwards to come to rest on the elevator.

As the forend reaches the rear and begins to move forward, the elevator lifts up the shell, lining it up with the barrel. As the bolt moves forward, the round slides into the chamber, and the final portion of the forend's travel locks the bolt into position. A pull of the trigger will fire the next round, where the cycle begins again.

Most pump-action firearms do not have any positive indication that they are out of ammunition, so it is possible to complete a cycle and have an empty chamber. The risk of running out of ammunition unexpectedly can be minimized in a tubular magazine firearm by topping off the magazine by loading new rounds to replace the rounds that have just been fired. This is especially important when hunting, as many locations have legal limits on the magazine capacity: for example, three rounds for shotguns and five rounds for rifles.

Trigger disconnectors

Modern pump shotgun designs, such as the Remington 870 and Mossberg 500, have a safety feature called a trigger disconnector, which disconnects the trigger from the sear as the bolt moves back, so that the trigger must be released and pulled again to fire the shotgun after it closes. Many early pump shotguns, such as the Winchester 1897, did not have trigger disconnectors, and would, if the trigger were held back, fire immediately upon closing. Some shooters feel this allows a higher rate of fire, and prefer models without this feature, such as the Ithaca 37 and Winchester Model 12.


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • pump-action — pump .action adj [only before noun] a pump action piece of equipment is operated by pulling or pressing a part in or out so that the contents come out in short bursts pump action shotgun/rifle …   Dictionary of contemporary English

  • pump-action — pump ,action adjective a pump action object is one that has a part that you push or pull to make something come out of it: a pump action rifle …   Usage of the words and phrases in modern English

  • pump-action — ► ADJECTIVE ▪ denoting a repeating firearm in which a new round is brought into the breech by a slide action in line with the barrel …   English terms dictionary

  • pump-action — ˈ ̷ ̷ˌ ̷ ̷ ̷ ̷ adjective Etymology: pump (I) + action of a shotgun or rifle : having an action that by the backward and forward motion of a sliding lever extracts and ejects the empty case, cocks the piece, and loads in a new round * * * ˈpump… …   Useful english dictionary

  • pump-action — adj. Pump action is used with these nouns: ↑shotgun …   Collocations dictionary

  • pump-action — adjective a pump action shotgun/hairspray etc a shotgun etc that is operated by pulling or pressing part of it in or out …   Longman dictionary of contemporary English

  • pump-action — /pump ak sheuhn/, adj. (of a shotgun or rifle) having an action that extracts the empty case, loads, and cocks the piece by means of a hand operated lever that slides backward and forward; slide action. [1910 15, Amer.] * * * …   Universalium

  • pump action — /ˈpʌmp ækʃən/ (say pump akshuhn) noun the sliding action of certain rifles and shotguns which reloads the weapon without the need to open the breech …   Australian English dictionary

  • pump action — noun action mechanism in a modern rifle or shotgun; a back and forward motion of a sliding lever ejects the empty shell case and cocks the firearm and loads a new round • Syn: ↑slide action • Hypernyms: ↑action, ↑action mechanism • Part Holonyms …   Useful english dictionary

  • pump action — noun a type of firearm action that uses a sliding handgrip to cycle the mechanism …   Wiktionary


Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.