Consolidation is a process by which soils decrease in volume. According to Karl Terzaghi "consolidation is any process which involves decrease in water content of a saturated soil without replacement of water by air." In general it is the process in which reduction in volume takes place by expulsion of water under long term static loads. It occurs when stress is applied to a soil that causes the soil particles to pack together more tightly, therefore reducing its bulk volume. When this occurs in a soil that is saturated with water, water will be squeezed out of the soil. The magnitude of consolidation can be predicted by many different methods. In the Classical Method, developed by Terzaghi, soils are tested with an oedometer test to determine their compression index. This can be used to predict the amount of consolidation.
When stress is removed from a consolidated soil, the soil will rebound, regaining some of the volume it had lost in the consolidation process. If the stress is reapplied, the soil will consolidate again along a recompression curve, defined by the recompression index. The soil which had its load removed is considered to be overconsolidated. This is the case for soils which have previously had glaciers on them. The highest stress that it has been subjected to is termed the preconsolidation stress. The over consolidation ratio or OCR is defined as the highest stress experienced divided by the current stress. A soil which is currently experiencing its highest stress is said to be normally consolidated and to have an OCR of one. A soil could be considered underconsolidated immediately after a new load is applied but before the excess pore water pressure has had time to dissipate.
The process of consolidation is often explained with an idealized system composed of a spring, a container with a hole in its cover, and water. In this system, the spring represents the compressibility or the structure itself of the soil, and the water which fills the container represents the pore water in the soil.
- The container is completely filled with water, and the hole is closed. (Fully saturated soil)
- A load is applied onto the cover, while the hole is still unopened. At this stage, only the water resists the applied load. (Development of excess pore water pressure)
- As soon as the hole is opened, water starts to drain out through the hole and the spring shortens. (Drainage of excess pore water pressure)
- After some time, the drainage of water no longer occurs. Now, the spring alone resists the applied load. (Full dissipation of excess pore water pressure. End of consolidation)
This method assumes consolidation occurs in only one-dimension. Laboratory data is used to construct a plot of strain or void ratio versus effective stress where the effective stress axis is on a logarithmic scale. The plot's slope is the compression index or recompression index. The equation for consolidation settlement of a normally consolidated soil can then be determined to be:
- δc is the settlement due to consolidation.
- Cc is the compression index.
- e0 is the initial void ratio.
- H is the height of the soil.
- σzf is the final vertical stress.
- σz0 is the initial vertical stress.
Cc can be replaced by Cr (the recompression index) for use in overconsolidated soils where the final effective stress is less than the preconsolidation stress. When the final effective stress is greater than the preconsolidation stress, the two equations must be used in combination to model both the recompression portion and the virgin compression portion of the consolidation process, as follows:
where σzc is the preconsolidation stress of the soil.
Secondary compression is the compression of soil that takes place after primary consolidation. Even after the reduction of hydrostatic pressure some compression of soil takes place at slow rate.this is known as secondary compression.Secondary compression is caused by creep, viscous behavior of the clay-water system, compression of organic matter, and other processes. In sand, settlement caused by secondary compression is negligible, but in peat, it is very significant. Due to secondary compression some of the highly viscous water between the points of contact is forced out.
Secondary compression is given by the formula
Where H0 is the height of the consolidating medium
e0 is the initial void ratio
Ca is the secondary compression index
The time for consolidation to occur can be predicted. Sometimes consolidation can take years. This is especially true in saturated clays because their hydraulic conductivity is extremely low, and this causes the water to take an exceptionally long time to drain out of the soil. While drainage is occurring, the pore water pressure is greater than normal because it is carrying part of the applied stress (as opposed to the soil particles).
- American Wick Drain- Largest manufacturer of soil-consolidating sheet drain in the U.S.
- Coduto, Donald (2001), Foundation Design, Prentice-Hall, ISBN 0-13-589706-8
- (Korean) Kim, Myung-mo (2000), Soil Mechanics (4 ed.), Seoul: Munundang, ISBN 89-7393-053-2
Topics in geotechnical engineering Soils Soil properties Soil mechanics Geotechnical investigation Laboratory tests Field tests Foundations Retaining walls Slope stability Earthquakes Geosynthetics Instrumentation for Stability Monitoring
Wikimedia Foundation. 2010.
Look at other dictionaries:
Consolidation — may refer to: Consolidation (business), the mergers or acquisitions of many smaller companies into much larger ones Consolidation (soil), a geological process whereby a soil decreases in volume Consolidation (media), consolidation of United… … Wikipedia
Soil compaction — occurs when weight of livestock or heavy machinery compresses soil, causing it to lose pore space. Affected soils become less able to absorb rainfall, thus increasing runoff and erosion. Plants have difficulty in compacted soil because the… … Wikipedia
Soil — For other uses, see Soil (disambiguation). A represents soil; B represents laterite, a regolith; C represents saprolite, a less weathered regolith; the bottommost layer represents bedrock … Wikipedia
Soil mechanics — is a discipline that applies principles of engineering mechanics, e.g. kinematics, dynamics, fluid mechanics, and mechanics of material, to predict the mechanical behavior of soils. Together with Rock mechanics, it is the basis for solving many… … Wikipedia
consolidation — 1. The binding of grains by cementing material to solid matrix . 2. The gradual reduction in the water content (void ratio) of a saturated soil, as a result of an increase in the pressure acting on it, because of the addition of… … Lexicon of Cave and Karst Terminology
Shear strength (soil) — Shear strength in reference to soil is a term used to describe the maximum strength of soil at which point significant plastic deformation or yielding occurs due to an applied shear stress. There is no definitive shear strength of a soil as it… … Wikipedia
Vacuum consolidation — (or vacuum preloading) is a soft soil improvement method that has been successfully used by geotechnical engineers and specialist sof ground improvement companies in countries such as China, Korea, Thailand and France for soil improvement or land … Wikipedia
National Cooperative Soil Survey — From a Report of Bureau of Soils, U.S. Department of Agriculture, 1923. The National Cooperative Soil Survey (NCSS) in the United States is a nation wide partnership of federal, regional, state, and local agencies and institutions. This… … Wikipedia
History of Soil Science — Justus von Liebig = The early concepts of soil were based on ideas developed by a German chemist, Justus von Liebig (1803 – 1873), and modified and refined by agricultural scientists who worked on samples of soil in laboratories, greenhouses, and … Wikipedia
Water content — Soil composition by phase: s soil (dry), v void (pores filled with water or air), w water, a air. V is volume, M is mass. Water content or moisture content is the quantity of water contained in a material, such as soil (called soil moisture),… … Wikipedia