The principles of air navigation are the same for all
aircraft, big or small. Air navigation involves successfully piloting an aircraft from place to place without getting lost, breaking the laws applying to aircraft, or endangering the safety of those on board or on the ground.
Air navigation differs from the navigation of surface craft in several ways: Aircraft travel at relatively high speeds, leaving less time to calculate their position en route. Aircraft normally cannot stop in mid-air to ascertain their position at leisure. Aircraft are safety-limited by the amount of fuel they can carry; a surface vehicle can usually get lost, run out of fuel, then simply await rescue. There is no in-flight rescue for most aircraft. And collisions with obstructions are usually fatal. Therefore, constant awareness of position is critical for aircraft pilots.
The techniques used for
navigationin the air will depend on whether the aircraft is flying under the visual flight rules(VFR) or the instrument flight rules(IFR). In the latter case, the pilot will navigate exclusively using instruments and radio navigation aids such as beacons, or as directed under radarcontrol by air traffic control. In the VFR case, a pilot will largely navigate using dead reckoningcombined with visual observations (known as pilotage), with reference to appropriate maps. This may be supplemented using radio navigation aids.
The first step in navigation is deciding where one wishes to go. A private pilot planning a flight under VFR will usually use an
aeronautical chartof the area which is published specifically for the use of pilots. This map will depict controlled airspace, radio navigation aids and airfields prominently, as well as hazards to flying such as mountains, tall radio masts, etc. It also includes sufficient ground detail - towns, roads, wooded areas - to aid visual navigation. In the UK, the CAA publishes a series of maps covering the whole of the UK at various scales, updated annually. The information is also updated in the notices to airmen, or NOTAMs.
The pilot will choose a route, taking care to avoid
controlled airspacethat is not permitted for the flight, restricted areas, danger areas and so on. The chosen route is plotted on the map, and the lines drawn are called the "track". The aim of all subsequent navigation is to follow the chosen track as accurately as possible. Occasionally, the pilot may elect on one leg to follow a clearly visible feature on the ground such as a railway track, river, highway, or coast.
When an aircraft is in flight, it is moving relative to the body of air it is flying in, therefore maintaining an accurate ground track is not as easy as it might appear, unless there is no wind at all — a very rare occurrence. Therefore the pilot must adjust "heading" to compensate for the wind, in order to follow the ground track. Initially the pilot will calculate headings to fly for each leg of the trip prior to departure, using the forecast wind directions and speeds supplied by the meteorological authorities for the purpose. These figures are generally accurate and updated several times per day, but the unpredictable nature of the weather means that the pilot must be prepared to make further adjustments in flight. A general aviation (GA) pilot will often make use of either the
E6Bflight computer - a type of slide rule- or a purpose designed electronic navigational computer to calculate initial headings."'
The primary instrument of navigation is the magnetic
compass. The needle or card aligns itself to magnetic north, which does not coincide with true north, so the pilot must also allow for this, called the magnetic variation(or declination). The variation that applies locally is also shown on the flight map. Once the pilot has calculated the actual headings required, the next step is to calculate the flight times for each leg. This is necessary to perform accurate dead reckoning. The pilot also needs to take into account the slower initial airspeed during climb to calculate the time to top of climb. It is also helpful to calculate the top of descent, or the point at which the pilot would plan to commence the descent for landing.
The flight time will depend on both the desired cruising speed of the aircraft, and the wind - a tailwind will shorten flight times, a headwind will increase them. The
E6Bhas scales to help pilots compute these easily.
point of no returnis the point on a flight at which a plane has just enough fuel, plus any mandatory reserve, to return to the airfield from which it departed. Beyond this point that option is closed, and the plane must proceed to some other destination.
Alternatively, with respect to a large region without airfields, e.g. an ocean, it can mean the point before which it is closer to turn around and after which it is closer to continue.
With regards to the "Point of NO Retutn" or what is sometimes referred to as the ETP(Equal time Point). The aricraft that is flying across the Ocean for example. Would be required to calculate ETPs for single engine, depressurization, and a normal ETP. All of which could actually be different points along the route. For example single engine and depressurization situations the aircraft would be forced to lower operational altitudes. Which would effect there fuel burn, cruise speed and ground speed. Each situation therefore would have a different ETP.
Commercial aircraft are not allowed to operate along a route with what is known as a wet foot print. So the ETP calculations serves as a planning stategy, so flight crews always have an out in a emergency event. Allowing a safe return to there chosen alternate.
The final stage is to note over which areas the route will go, and to make a note of all of the things to be done - which ATC units to contact, the appropriate frequencies, visual reporting points, and so on. It is also important to note which pressure setting regions will be entered, so that the pilot can ask for the
QNH(air pressure) of those regions. Finally, the pilot should have in mind some alternative plans in case the route cannot be flown for some reason - unexpected weather conditions being the most common. At times the pilot may be required to file a flight plan for an alternate destination and to carry adequate fuel for this. The more work a pilot can do on the ground prior to departure, the easier it will be in the air.
In many respects this is similar to VFR
flight planningexcept that the task is generally made simpler by the use of special charts that show IFR routes from beacon to beacon with the lowest safe altitude(LSALT), bearings (in both directions) and distance marked for each route. IFR pilots may fly on other routes but they then have to do all of these calculations themselves with the LSALT calculation being the most difficult. The pilot then needs to look at the weather and minimum specifications for landing at the destination airport and the alternate requirements. The pilot must also comply with all the rules including their legal ability to use a particular instrument approach depending on how recently they last performed one.
Once in flight, the pilot must take pains to stick to plan, otherwise getting lost is all too easy. This is especially true if flying over featureless terrain. This means that the pilot must stick to the calculated headings, heights and speeds as accurately as possible. The visual pilot must regularly compare the ground with the map, (
pilotage) to ensure that the track is being followed although adjustments are generally calculated and planned. Usually, the pilot will fly for some time as planned to a point where features on the ground are easily recognised. If the wind is different from that expected, the pilot must adjust heading accordingly, but this is not done by guesswork, but by mental calculation - often using the 1 in 60 rule. For example a two degree error at the halfway stage can be corrected by adjusting heading by four degrees the other way to arrive in position at the end of the leg. This is also a point to reassess the estimated time for the leg. A good pilot will become adept at applying a variety of techniques to stay on track.
While the compass is the primary instrument used to determine one's heading, pilots will usually refer instead to the
direction indicator(DI), a gyroscopically driven device which is much more stable than a compass. The compass reading will be used to correct for any drift ( precession) of the DI periodically. The compass itself will only show a steady reading when the aircraft has been in straight and level flight long enough to allow it to settle.
Should the pilot be unable to complete a leg - for example bad weather arises, or the visibility falls below the minima permitted by the pilot's license, the pilot must "divert" to another route. Since this is an unplanned leg, the pilot must be able to mentally calculate suitable headings to give the desired new track. Using the
E6Bin flight is usually impractical, so mental techniques to give rough and ready results are used. The wind is usually allowed for by assuming that sineA = A, for angles less than 60° (when expressed in terms of a fraction of 60° - e.g. 30° is 1/2 of 60°, and sine 30° = 0.5), which is adequately accurate. A method for computing this mentally is the clock code. However the pilot must be extra vigilant when flying diversions to maintain awareness of position.
Some diversions can be temporary - for example to skirt around a local storm cloud. In such cases, the pilot can turn 60 degrees away his desired heading for a given period of time. Once clear of the storm, he can then turn back in the opposite direction 120 degrees, and fly this heading for the same length of time. This is a 'wind-star' maneuver and, with no winds aloft, will place him back on his original track with his trip tme increased by the length of one diversion leg.
Good pilots use all means available to help navigate. Many GA aircraft are fitted with a variety of radio navigation aids, such as
Automatic direction finder(ADF), VHF omnidirectional range(VOR) and GNSS.
non-directional beacons (NDBs) on the ground to drive a display which shows the direction of the beacon from the aircraft. The pilot may use this bearing to draw a line on the map to show the bearing from the beacon. By using a second beacon, two lines may be drawn to locate the aircraft at the intersection of the lines. This is called a "cross-cut". Alternatively, if the track takes the flight directly overhead a beacon, the pilot can use the ADF instrument to maintain heading relative to the beacon, though "following the needle" is bad practice, especially in the presence of a strong cross wind - the pilot's actual track will spiral in towards the beacon, not what was intended. NDBs also can give erroneous readings because they use very long wavelengths, which are easily bent and reflected by ground features and the atmosphere. NDBs continue to be used as a common form of navigation in some countries with relatively few navigational aids.
VOR is a more sophisticated system, and is still the primary air navigation system established for aircraft flying under IFR in those countries with many navigational aids. In this system, a beacon emits a specially modulated signal which consists of two
sine waves which are out of phase. The phase difference corresponds to the actual bearing relative to true north that the receiver is from the station. The upshot is that the receiver can determine with certainty the exact bearing from the station. Again, a cross-cut is used to pinpoint the location. Many VOR stations also have additional equipment called DME ( distance measuring equipment) which will allow a suitable receiver to determine the exact distance from the station. Together with the bearing, this allows an exact position to be determined from a single beacon alone. For convenience, some VOR stations also transmit local weather information which the pilot can listen in to, perhaps generated by an Automated Surface Observing System.
Prior to the advent of GNSS,
Celestial Navigationwas also used by trained navigators on military bombers and transport aircraft in the event of all electronic navigational aids being turned off in time of war. Originally navigators used an astrodome and regular sextantbut the more streamlined periscopic sextant was used from the 1940s to the 1990s.
Finally, an aircraft may be supervised from the ground using surveilance information from e.g.
radaror multilateration. ATC can then feed back information to the pilot to help establish position, or can actually tell the pilot the position of the aircraft, depending on the level of ATC service the pilot is receiving.
The use of GNSS in aircraft is becoming increasingly common. GNSS provides very precise aircraft position, altitude, heading and ground speed information. GNSS makes navigation precision once reserved to large
RNAV-equipped aircraft available to the GA pilot. Recently, more and more airports include GNSS instrument approaches. GNSS approaches consist of either overlays to existing non-precision approaches or stand-alone GNSS non-precision approaches.
Master Navigator Software
Flight management system
Instrument Landing System
Air traffic obstacle
* [http://www.elisanet.fi/master.navigator/xCalc/ Earth navigation calculator for Windows (free)]
* [http://flyawaysimulation.com/content-cat-2.html Fly Away - Air Navigation tutorials]
Wikimedia Foundation. 2010.
Look at other dictionaries:
air navigation — noun the science and technology of determining the position of an aircraft with respect to the surface of the earth and accurately maintaining a desired course … Wiktionary
air navigation — science and technology of piloting an airplane and determining its position … English contemporary dictionary
Air Navigation Service Provider — An Air Navigation Service Provider (ANSP) is the organisation that separates aircraft both on the ground and in flight in a dedicated block of airspace on behalf of a state or a number of states. Air Navigation Service Providers are either… … Wikipedia
Air Navigation and Engineering Company — L Air Navigation and Engineering Company était un constructeur d avions britanniques. Elle a été créée en 1919 à cessé ses activités en 1927. Sommaire 1 Historique 2 Avions construits 3 Automobile construite 4 R … Wikipédia en Français
air navigation facility — Any facility used, available for use, or designed for use as an aid to air navigation, including landing areas; lights; any apparatus or equipment for disseminating weather information, signaling, radio–direction finding, or radio or other… … Aviation dictionary
Air Navigation and Engineering Company — Aircraft Navigation and Engineering Company Limited was a British aircraft manufacturer from its formation in 1919 to 1927.HistoryThe company was formed in 1919 when the Blériot SPAD Manufacturing Company Limited was renamed. The company was… … Wikipedia
air navigation facility — Any facility used in, available for use in, or designed for use in, aid of air navigation, including landing areas, lights, any apparatus or equipment for disseminating weather information, for signalling, for radio directional finding, or for… … Ballentine's law dictionary
polar air navigation — Air navigation in the region of the north or south pole. Polar air navigation poses special problems because of the convergence of meridians, erratic behavior of magnetic compasses, unreliability of radio performance and scarcity of radio… … Aviation dictionary
future air navigation systems — Air navigation systems designed to satisfy national or international stated requirements, primarily through the use of satellite technology. Future air navigation system (FANS) … Aviation dictionary
Future Air Navigation System — The world s Air Traffic Control system still uses components defined in the 1940s s following the 1944 meeting in Chicago which launched the creation of the International Civil Aviation Organisation (ICAO). This traditional ATC system uses analog … Wikipedia