Manchester–Sheffield–Wath electric railway
The Manchester-Sheffield-Wath electric railway was an early electrification scheme on British railways. The route featured long ascents on both sides of the Pennines with the long Woodhead Tunnel at its central summit close to the Woodhead pass. This also led to the route being called the Woodhead Line.
The main route ran from Manchester London Road (later Manchester Piccadilly) over the Pennines, through the Woodhead Tunnel to Penistone, where the Wath line split. The main line then proceeded through Sheffield Victoria Station and on to Rotherwood sidings. The Wath line ran from Penistone to Wath marshalling yard in the heart of the South Yorkshire coalfields.
Minor electrified branches off the main line ran to the locomotive depot at Reddish on the Fallowfield Loop line, to Glossop (for local passenger trains), Dewsnap sidings (all at the Manchester end) and Tinsley Marshalling Yard (at the Sheffield end).
Following developments with electric traction in the USA, the Great Central Railway (GCR) first considered the electrification of the line prior to World War I. No detailed plans were drawn up, but by the 1920s the high levels of heavy freight traffic made steam operation increasingly problematic. Things were interrupted by the 1923 grouping of the railways, which saw the GCR absorbed into the London and North Eastern Railway (LNER).
The operational problems remained into the 1930s. In 1935 the government made credits available to the railways to provide relief for unemployed persons in the Great Depression so the LNER restarted the project: planning and works for electrification commenced. The system was to be electrified at 1,500V DC, similar to the Dutch style of electrification that had also been used on the LNER's Newport-Shildon line. This system had the advantage that regenerative braking could easily be employed; this provided braking traction by allowing an electric locomotive's motors to act as brakes, thus assisting with control of heavy freight trains when running downhill. The power generated by a descending train's braking action was fed back to the overhead lines and either used by other trains requiring power in the same block of line, or dissipated as heat in resistive loads at the electrical sub-stations.
Some gantries for the overhead wires were erected and a prototype locomotive was constructed. However World War II intervened. The prototype locomotive was loaned to the Netherlands immediately after World War II to assist in working the war-damaged railways there; in the process of this it acquired the nickname "Tommy" - which later, after repatriation to Britain, was used officially.
In 1948 the assets of the LNER were nationalised as a part of British Railways. Nearly 30 years had elapsed and still the operational problems remained, so money was made available to complete the electrification project. By now the state of the original Woodhead tunnels meant that a new twin-track tunnel had to be built to replace the two original single-track bores. Thurgoland tunnel gained a new bore to alleviate clearance problems in the original tunnel. New electric locomotive facilities were built at Reddish, Darnall and Wath, and two classes of locomotive were built at Gorton locomotive works, Manchester, exclusively for the line. These were the EM1 (Class 76) Bo+Bo (the + signifiying that the bogies were articulated) mixed-traffic locomotives and seven larger EM2 (Class 77) Co-Co locomotives for express passenger services.
However, to save on costs, the Cheshire Lines Committee (CLC) loop line into Manchester Central station was not electrified, as was originally in the plan: Manchester-bound passenger trains would terminate at London Road (later Piccadilly), while those few passenger trains destined for further afield would change locomotives at Guide Bridge.
The Wath to Penistone section was the first to be energised on 2 February 1952. Completion of the main line was delayed until 1954 by a collapse in the new Woodhead tunnel, and also by the decision to completely re-signal the whole main line with colour-light signals after sighting problems with the semaphore signals on the Wath branch. On 30 May 1954 electric trains began running through the tunnel and the Manchester to Penistone section was fully energised on 14 June. The Sheffield Victoria to Penistone section followed on 20 September 1954. At this time the system had its official opening despite not being fully complete: the final few miles from Sheffield Victoria to the system's eastern extremity at Rotherwood was declared open on 3 January 1955.
The benefits of electrification were immediately apparent: Sheffield to Manchester expresses now completed the journey in 56 minutes as opposed to 65 minutes with steam traction; an 850 ton coal train took a mere 66 minutes between Wath and Dunford Bridge as opposed to nearly two and a half hours powered by steam.
The Worsborough (or Wentworth) incline was a formidable feature on the Wath to Penistone section. This line was opened east of Silkstone in 1880 to alleviate congestion at Barnsley. Although nominally 1 in 40, colliery subsidence had made sections of the bank much steeper. The difficulty in operating this steeply-graded section (which included the two Silkstone tunnels) with steam traction was a key reason for electrification. Prior to electrification a unique powerful Garratt locomotive was built to act as a banker for this section of line, otherwise the normal mode of operation was for two or sometimes even three bankers for the Worsborough incline plus a pilot locomotive to assist from Wath to Dunford Bridge. Even with five locomotives, heavy trains had slowed to a walking pace by Silkstone. After electrification, much heavier coal trains could be handled up the bank; however problems with unfitted trains running away on the downgrades west of the Pennines restricted weights on such trains. In later years MGR (Merry-Go-Round) coal trains, running direct from pit to power station became the main traffic with the coal carried in block trains of 30, 32-tonne capacity air-braked wagons. These were normally double-headed by two Class 76 locomotives to their destination with two additional Class 76s banking at the rear from Wombwell to Silkstone. This was the only section of railway in the UK to be regularly operated by four locomotives per train. A "Clearcall" intercom system (via the overhead electric wires) was developed to allow the crews of the front and rear locomotives to communicate, replacing earlier air-horn codes.
The purpose-built power control centre for the line was adjacent to Penistone station. The building still stands, but has been adapted for alternative commercial use.
As much of the line was prone to colliery subsidence, many of the portal structures which supported the overhead wires contained crossbeams which were designed to be easily adjustable upwards or downwards, using permanent way cranes; the ground-level trackside power feed, communications and signalling cables were similarly adjustable.
In 1965 the scheme was extended to take in the brand new Tinsley Marshalling Yard in Sheffield. The locomotive facilities at the Sheffield end of the line were moved from Darnall to the new Tinsley depot. The overhead line equipment on this section was designed to be easily convertible to 25kV AC electrification, which by now had been accepted as the standard overhead electrification system for BR.
Some limitations of the Woodhead electrification became apparent, especially with the advent of the double-headed, double-banked merry-go-round unit trains previously mentioned. Whilst such a train was climbing Worsborough Incline, all other electric trains were prohibited from entering upon or moving within the power section between Strafford Crossing and Aldam Junction, lest the substations at these two locations trip out from the massive current draw. Heavy current loads also caused flashovers in the oil-impregnated paper-insulated, lead-covered 33 kV ground-level feeder cable at locations where cable segments were joined together in sealed boxes; such loads were not present in the MSJ&A and Great Eastern 1.5 kV DC schemes, both of which served only EMU trains and not locomotive-hauled ones.
Electric trans-Pennine passenger services lasted just 16 years. The Beeching Report had specified that only one Manchester-Sheffield route should stay open to passengers and that route would be Woodhead. However local opposition to the closure of the alternative Hope Valley line, the high cost of providing an electrified link into Sheffield Midland station as Sheffield Victoria was slated for closure, and the impending opening of the massive Fiddlers Ferry Power Station requiring even more trans-Pennine freight train paths from the South Yorkshire Coalfield, all conspired against the Woodhead line which thus closed to passengers on 5 January 1970. A local electric service remained at the Manchester end of the line and the Sheffield - Penistone service was left in the hands of diesel trains. The Class 77 express passenger train locomotives were sold to the Netherlands Railways, becoming NS Class 1500.
By the late 1970s freight traffic, even including South Yorkshire coal, had declined to the extent that British Rail took the decision to close the route, ultimately effective 18 July 1981; only the Manchester-Glossop/Hadfield local passenger trains were left running. BR claimed that the cost of replacing the out-of-date and non-standard equipment on the main section of the line was prohibitive. All but one of the remaining Class 76 locomotives were scrapped. The Wath branch was rapidly lifted between Wombwell Main Junction and West Silkstone Junction. As a part of the closure agreement, the track on the Sheffield-Penistone-Hadfield section of the route was left in place for five years. 1986 saw much of the remaining track lifted, except for the sections in the vicinity of Penistone station (which remained open for Sheffield-Huddersfield trains), and east of Deepcar which remained for both freight and passenger traffic in the Sheffield area.
In December 1984 the remaining equipment at the Manchester end of the line was modified to the by now standard 25kV AC, thus ending the use of 1,500V DC overhead electrification on British Rail. The Class 506 were withdrawn at the same time, being replaced by Class 303 EMUs from the Glasgow area. The line is now operated by Class 323 EMUs.
- ^ Modernisation of British Railways: The System of Electrification for British Railways, London: British Transport Commission, 1956, p. 7, http://www.railwaysarchive.co.uk/docsummary.php?docID=1135
Wikimedia Foundation. 2010.
Look at other dictionaries:
Manchester-Sheffield-Wath electric railway — The Manchester Sheffield Wath electric railway was an early electrification scheme on British railways. The route featured long ascents on both sides of the Pennines with the long Woodhead Tunnel at its central summit close to the Woodhead pass.… … Wikipedia
Railway electrification in Great Britain — describes the past and present electrification systems used to supply traction current to railways and tramways in Great Britain with a chronological record of development, a list of lines using each system, and a history and a technical… … Wikipedia
Wath marshalling yard — Wath marshalling yard, also known as Wath concentration yard, was a large railway marshalling yard specifically designed for the concentration of coal traffic. It was set at the heart of the South Yorkshire Coalfield, at Wath upon Dearne,… … Wikipedia
Sheffield Victoria railway station — Infobox UK disused station name = Sheffield Victoria gridref = SK362880 caption = Sheffield Victoria, as seen in 1971 manager = Manchester, Sheffield and Lincolnshire Railway Great Central Railway owner = London and North Eastern Railway London… … Wikipedia
Sheffield district rail rationalisation plan of the 1960s — The Sheffield District Rail Rationalisation Plan was a series of linked railway civil engineering projects, station and line closures and train route changes that took place in and around Sheffield, South Yorkshire. The majority of these changes… … Wikipedia
List of current systems for electric rail traction — This a list of the power supply systems that are, or have been, used for tramway and railway electrification systems. Note that the voltages are nominal and vary depending on load and distance from the substation. Many modern trams and trains use … Wikipedia
Dearne District Light Railway — The Dearne District Light Railway was a tramway linking Barnsley with the towns of Wombwell, Wath, Bolton on Dearne and Thurnscoe. Opened on 12 July 1924, it was the last street tramway to be built in the UK and one of the first to shut. A car… … Wikipedia
Hadfield railway station — Infobox UK station name = Hadfield code = HDF manager = Northern Rail locale = Hadfield borough = High Peak start = platforms = 1 usage0405 = 0.208 usage0506 = 0.212 usage0607 = 0.213Hadfield railway station serves the village of Hadfield in… … Wikipedia
Woodhead Line — The Woodhead Line was a railway line linking Sheffield, Penistone and Manchester in the north of England. A key feature of the route is the passage under the high moorlands of the northern Peak District through the Woodhead Tunnels. The line was… … Wikipedia
Penistone Line — Overview Type Heavy rail System National Rail Status Operational Locale South Yorkshire West Yorkshire She … Wikipedia