Fluoroscopy is an imaging technique commonly used by
physiciansto obtain real-time moving images of the internal structures of a patient through the use of a fluoroscope. In its simplest form, a fluoroscope consists of an x-raysource and fluorescent screen between which a patient is placed. However, modern fluoroscopes couple the screen to an x-ray image intensifierand CCD video cameraallowing the images to be played and recorded on a monitor.
The use of x-rays, a form of
ionizing radiation, requires that the potential risks from a procedure be carefully balanced with the benefits of the procedure to the patient. While physicians always try to use low doserates during fluoroscopic procedures, the length of a typical procedure often results in a relatively high absorbed doseto the patient. Recent advances include the digitization of the images captured and flat-panel detector systems which reduce the radiation dose to the patient still further.
The beginning of fluoroscopy can be traced back to
8 November 1895when Wilhelm Röntgennoticed a bariumscreen fluorescing as a result of being exposed to what he would later call x-rays. Within months of this discovery, the first fluoroscopes were created. Early fluoroscopes were simply cardboard funnels, open at narrow end for the eyes of the observer, while the wide end was closed with a thin cardboard piece that had been coated on the inside with a layer of fluorescent metal salt. The fluoroscopic image obtained in this way is rather faint. Thomas Edisonquickly discovered that calcium tungstatescreens produced brighter images and is credited with designing and producing the first commercially available fluoroscope. In its infancy, many incorrectly predicted that the moving images from fluoroscopy would completely replace the still x-ray radiographs, but the superior diagnostic quality of the earlier radiographsprevented this from occurring.
Ignorance of the harmful effects of x-rays resulted in the absence of standard radiation safety procedures which are employed today. Scientists and physicians would often place their hands directly in the x-ray beam resulting in
radiation burns. Trivial uses for the technology also resulted, including the shoe-fitting fluoroscopeused by shoe stores in the 1930s-1950s. [http://www.orau.org/ptp/collection/shoefittingfluor/shoe.htm]
Due to the limited light produced from the fluorescent screens, early
radiologistswere required to sit in a darkened room, in which the procedure was to be performed, accustomizing their eyes to the dark and thereby increasing their sensitivity to the light. The placement of the radiologist behind the screen resulted in significant radiation doses to the radiologist. Red adaptation goggleswere developed by Wilhelm Trendelenburgin 1916 to address the problem of dark adaptationof the eyes, previously studied by Antoine Beclere. The resulting red light from the goggles' filtration correctly sensitized the physician's eyes prior to the procedure while still allowing him to receive enough light to function normally.
The development of the
X-ray image intensifierand the television camerain the 1950s revolutionized fluoroscopy. The red adaptation gogglesbecame obsolete as image intensifiers allowed the light produced by the fluorescent screen to be amplified, allowing it to be seen even in a lighted room. The addition of the cameraenabled viewing of the image on a monitor, allowing a radiologist to view the images in a separate room away from the risk of radiation exposure.
More modern improvements in screen
phosphors, image intensifiers and even flat panel detectorshave allowed for increased image quality while minimizing the radiation dose to the patient. Modern fluoroscopes use CsI screens and produce noise-limited images, ensuring that the minimal radiation dose results while still obtaining images of acceptable quality.
Because fluoroscopy involves the use of x rays, a form of
ionizing radiation, all fluoroscopic procedures pose a potential health risk to the patient. Radiation doses to the patient depend greatly on the size of the patient as well as length of the procedure, with typical skin dose rates quoted as 20-50 mGy/min. Exposure times vary depending on the procedure being performed, but procedure times up to 75 minutes have been documented. Because of the long length of some procedures, in addition to standard cancer-inducing stochastic radiation effects, deterministic radiation effects have also been observed ranging from mild erythema, equivalent of a sun burn, to more serious burns.
A study has been performed by the
Food and Drug Administration(FDA) entitled "Radiation-induced Skin Injuries from Fluoroscopy" [http://www.fda.gov/cdrh/rsnaii.html] with an additional publication to minimize further fluoroscopy-induced injuries, "Public Health Advisory on Avoidance of Serious X-Ray-Induced skin Injuries to Patients During Fluoroscopically-Guided Procedures" [http://www.fda.gov/cdrh/fluor.html] .
While deterministic radiation effects are a possibility,
radiation burnsare not typical of standard fluoroscopic procedures. Most procedures sufficiently long in length to produce radiation burns are part of necessary life-saving operations.
The first fluoroscopes consisted of an x-ray source and fluorescent screen between which the patient would be placed. As the x rays pass through the patient, they are attenuated by varying amounts as they interact with the different internal structures of the body, casting a
shadowof the structures on the fluorescent screen. Images on the screen are produced as the unattenuated x rays interact with atoms in the screen through the photoelectric effect, giving their energy to the electrons. While much of the energy given to the electrons is dissipated as heat, a fraction of it is given off as visible light, producing the images. Early radiologistswould adapt their eyes to view the dim fluoroscopic images by sitting in darkened rooms, or by wearing red adaptation goggles.
X-ray Image Intensifiers
The invention of
X-ray image intensifiers in the 1950s allowed the image on the screen to be visible under normal lighting conditions, as well as providing the option of recording the images with a conventional camera. Subsequent improvements included the coupling of, at first, video cameras and, later, CCD cameras to permit recording of moving images and electronic storage of still images.
Modern image intensifiers no longer use a separate fluorescent screen. Instead, a
caesium iodidephosphor is deposited directly on the photocathode of the intensifier tube. On a typical general purpose system, the output image is approximately 105 times brighter than the input image. This "brightness gain" comprises a "flux gain" (amplification of photon number) and "minification gain" (concentration of photons from a large input screen onto a small output screen) each of approximately 100. This level of gain is sufficient that quantum noise, due to the limited number of x-ray photons, is a significant factor limiting image quality.
Image intensifiers are available with input diameters of up to 45 cm, and a resolution of approximately 2-3 line pairs mm-1.
The introduction of flat-panel detectors allows for the replacement of the image intensifier in fluoroscope design. Flat panel detectors offer increased sensitivity to X-rays, and therefore have the potential to reduce patient radiation dose. Temporal resolution is also improved over image intensifiers, reducing motion blurring. Contrast ratio is also improved over image intensifiers: flat-panel detectors are linear over a very wide latitude, whereas image intensifiers have a maximum contrast ratio of about 35:1. Spatial resolution is approximately equal, although an image intensifier operating in 'magnification' mode may be slightly better than a flat panel.
Flat panel detectors are considerably more expensive to purchase and repair than image intensifiers, so their uptake is primarily in specialties that require high-speed imaging, e.g., vascular imaging and
In addition to spatial blurring factors that plague all x-ray imaging devices, caused by such things as
Lubberts effect, K-fluorescencereabsorption and electronrange, fluoroscopic systems also experience temporal blurring due to system lag. This temporal blurring has the effect of averaging frames together. While this helps reduce noise in images with stationary objects, it creates motion blurring for moving objects. Temporal blurring also complicates measurements of system performancefor fluoroscopic systems.
Common procedures using fluoroscopy
*Investigations of the
gastrointestinal tract, including barium enemas, barium meals and barium swallows, and enteroclysis.
Orthopaedic surgeryto guide fracture reduction and the placement of metalwork.
Angiographyof the leg, heart and cerebral vessels.
* Placement of a PICC (
peripherally inserted central catheter)
* Placement of a weighted feeding tube (e.g. Dobhoff) into the duodenum after previous attempts without fluoroscopy have failed.
*Urological surgery – particularly in retrograde
*Implantation of cardiac rhythm management devices (pacemakers,
implantable cardioverter defibrillators and cardiac resynchronization devices)
Another common procedure is the modified barium swallow study during which
barium-impregnated liquids and solids are ingested by the patient. A radiologist records and, with a speech pathologist, interprets the resulting images to diagnose oral and pharyngeal swallowing dysfunction. Modified barium swallow studies are also used in studying normal swallow function.
* [http://www.healthsystem.virginia.edu/uvahealth/adult_radiology/fluoros.cfm What is fluoroscopy?] University of Virginia
* [http://www.fda.gov/cdrh/radhealth/products/fluoroscopy.html Fluoroscopy] FDA Radiological Health Program
*" [http://www.straightdope.com/classics/a2_414a.html Were those old shoe store fluoroscopes a health hazard?] " at
Straight Dope, 27 November 1987
* [http://www.medical.siemens.com/webapp/wcs/stores/servlet/CategoryDisplay?categoryId=12753&langId=-1&catalogId=-1&storeId=10001&catTree=100001,12784,12753&overviewId=12753&userviewId=12815&parentName=Fluoroscopy&level=0 - Fluoroscopy Equipment and Information from Siemens Medical]
Wikimedia Foundation. 2010.
Look at other dictionaries:
Fluoroscopy — Flu or*os co*py, n. Examination of an object, as the human body, by exposing it to the X rays and observing the shadow cast upon a fluorescent screen; cryptoscopy. [Webster 1913 Suppl.] … The Collaborative International Dictionary of English
Fluoroscopy — Fluoroscopy. См. Рентгеноскопия. (Источник: «Металлы и сплавы. Справочник.» Под редакцией Ю.П. Солнцева; НПО Профессионал , НПО Мир и семья ; Санкт Петербург, 2003 г.) … Словарь металлургических терминов
fluoroscopy — 1896, from fluor (see FLUORESCENCE (Cf. fluorescence)) + oscopy (see SCOPE (Cf. scope)) … Etymology dictionary
fluoroscopy — ☆ fluoroscopy [flô räs′kə pē, flooräs′kə pē ] n. examination by means of a fluoroscope fluoroscopist n … English World dictionary
Fluoroscopy — An x ray procedure that makes it possible to see internal organs in motion. Fluoroscopy uses x ray to produce real time video images. After the x rays pass through the patient, instead of using film, they are captured by a device called an image… … Medical dictionary
fluoroscopy — fluoroskopija statusas T sritis Standartizacija ir metrologija apibrėžtis Žmogaus organų rentgeninio vaizdo gavimas fluorescenciniame ekrane. atitikmenys: angl. fluoroscopy vok. Durchleuchtung, f; Röntgendurchleuchtung, f rus. флуороскопия, f… … Penkiakalbis aiškinamasis metrologijos terminų žodynas
fluoroscopy — fluoroskopija statusas T sritis fizika atitikmenys: angl. fluoroscopy vok. Durchleuchtung, f; Röntgendurchleuchtung, f rus. флуороскопия, f pranc. fluoroscopie, f … Fizikos terminų žodynas
fluoroscopy — noun see fluoroscope I … New Collegiate Dictionary
fluoroscopy — fluoroscopist, n. /floo ros keuh pee, flaw , floh /, n. the use of or examination by means of a fluoroscope. [1895 1900; FLUORO + SCOPY] * * * … Universalium
fluoroscopy — noun examination using a fluoroscope … Wiktionary