Optical parametric oscillator


Optical parametric oscillator
Infrared optical parametric oscillator

An optical parametric oscillator (OPO) is a parametric oscillator which oscillates at optical frequencies. It converts an input laser wave (called "pump") into two output waves of lower frequency (ωsi) by means of second order nonlinear optical interaction. The sum of the output waves frequencies is equal to the input wave frequency: ωs + ωi = ωp. For historic reasons, the two output waves are called "signal" and "idler", where the wave with higher frequency is called signal. A special case is the degenerate OPO, when the output frequency is one-half the pump frequency, ωs = ωi = ωp / 2.

Contents

Overview

The OPO consists essentially of an optical resonator and a nonlinear optical crystal. The optical resonator serves to resonate at least one of signal and idler waves. In the nonlinear optical crystal, the pump, signal and idler waves overlap. The interaction between these three waves leads to amplitude gain for signal and idler waves (parametric amplification) and a corresponding deamplification of the pump wave. The gain allows the resonating wave(s) (signal or idler or both) to oscillate in the resonator, compensating the loss that the resonating wave(s) experience(s) at each round-trip. This loss includes the loss due to outcoupling by one of the resonator mirrors, which provides the desired output wave. Since the (relative) loss is independent of the pump power, but the gain is dependent on pump power, at low pump power there is insufficient gain to support oscillation. Only when the pump power reaches a particular threshold level, oscillation occurs. Above threshold, the gain depends also on the amplitude of the resonated wave. Thus, in steady-state operation, the amplitude of the resonated wave is determined by the condition that this gain equals the (constant) loss. The circulating amplitude increases with increasing pump power, and so does the output power.

The photon conversion efficiency, the number of output photons per unit time in the output signal or idler wave relative to number of pump photons incident per unit time into the OPO can be high, in the range of tens of percent. Typical threshold pump power is between tens of milliwatts to several watts, depending on losses of the resonator, the frequencies of the interacting light, the intensity in the nonlinear material, and its nonlinearity. Output powers of several watts can be achieved. There exist both continuous-wave and pulsed OPOs. The latter are easier to build, since the high intensity lasts only for a tiny fraction of a second, which damages the nonlinear optical material and the mirrors less than a continuous high intensity.

In the optical parametric oscillator the initial idler and signal waves are taken from background waves, which are always present. If the idler wave is given from the outside along with the pump beam, then the process is called difference frequency generation (DFG). This is a more efficient process than optical parametric oscillation, so that also the threshold intensity is lower.

In order to change the output wave frequencies, one can change the pump frequency or the phasematching properties of the nonlinear optical crystal. This latter is accomplished by changing its temperature or orientation or quasi-phasematching period (see below). For fine-tuning one can also change the optical path length of the resonator. In addition, the resonator may contain elements to suppress mode-hops of the resonating wave. This often requires active control of some element of the OPO system.

If the nonlinear optical crystal cannot be phase-matched, quasi-phase-matching (QPM) can be employed. This is accomplished by periodically changing the nonlinear optical properties of the crystal, mostly by periodical poling. With a suitable range of periods, output wavelengths from 700 nm to 5000 nm can be generated in periodically poled lithium niobate (PPLN). Common pump sources are neodymium lasers at 1.064 µm or 0.532 µm.

An important feature of the OPO is the coherence and the spectral width of the generated radiation. When the pump power is significantly above threshold, the two output waves are, to a very good approximation, coherent states (laser-like waves). The linewidth of the resonated wave is very narrow (as low as several kHz). The nonresonated generated wave also exhibits narrow linewidth if a pump wave of narrow linewidth is employed. Narrow-linewidth OPOs are widely used in spectroscopy.[1]

Quantum properties of the generated light beams

KTP crystals in an OPO

The OPO is the physical system most widely used to generate squeezed coherent states and entangled states of light in the continuous variables regime. Many demonstrations of quantum information protocols for continuous variables were realized using OPOs.[2][3][3][4]

The downconversion process really occurs in the single photon regime: each pump photon that is annihilated inside the cavity gives rise to a pair of photons in the signal and idler intracavity modes. This leads to a quantum correlation between the intensities of signal and idler fields, so that there is squeezing in the subtraction of intensities,[5] which motivated the name "twin beams" for the downconverted fields. The highest squeezing level attained was 10.12 ± 0.15 dB.[6]

It turns out that the phases of the twin beams are quantum correlated as well, leading to entanglement, theoretically predicted in 1988.[7] Below threshold, entanglement was measured for the first time in 1992,[8] and in 2005 above threshold.[9]

Above threshold, the pump beam depletion makes it sensitive to the quantum phenomena happening inside the crystal. The first measurement of squeezing in the pump field after parametric interaction was done in 1997.[10] It has been recently predicted that all three fields (pump, signal and idler) must be entangled.[11]

Not only intensity and phase of the twin beams share quantum correlations, but also do their spatial modes.[12] This feature could be used to enhance signal to noise ratio in image systems.

The OPO is being employed nowadays as a source of squeezed light tuned to atomic transitions, in order to study how the atoms interact with squeezed light.[13]

References

  1. ^ F. J. Duarte (Ed.), Tunable Laser Applications, 2nd Ed. (CRC, New York, 2009) Chapter 2.
  2. ^ J. Jing, J. Zhang, Y. Yan, F. Zhao, C. Xie, and K. Peng (2003). "Experimental Demonstration of Tripartite Entanglement and Controlled Dense Coding for Continuous Variables". Phys. Rev. Lett. 90 (16): 167903. arXiv:quant-ph/0210132. Bibcode 2003PhRvL..90p7903J. doi:10.1103/PhysRevLett.90.167903. 
  3. ^ a b S. Koike, H. Takahashi, H. Yonezawa, N. Takei, S. L. Braunstein, T. Aoki, and A. Furusawa (2006). Phys. Rev. Lett. 96: 060504. arXiv:quant-ph/0508007. Bibcode 2006PhRvL..96a0504C. doi:10.1103/PhysRevLett.96.010504. 
  4. ^ N. Takei, H. Yonezawa, T. Aoki, and A. Furusawa (2005). "High-Fidelity Teleportation beyond the No-Cloning Limit and Entanglement Swapping for Continuous Variables". Phys. Rev. Lett. 94 (22): 220502. arXiv:quant-ph/0501086. Bibcode 2005PhRvL..94v0502T. doi:10.1103/PhysRevLett.94.220502. 
  5. ^ A. Heidmann, R. J. Horowicz, S. Reynaud, E. Giacobino, C. Fabre, and G. Camy (1987). "Observation of Quantum Noise Reduction on Twin Laser Beams". Phys. Rev. Lett. 59 (22): 2555. Bibcode 1987PhRvL..59.2555H. doi:10.1103/PhysRevLett.59.2555. 
  6. ^ Schnabel et al.; Mehmet, Moritz; Chelkowski, Simon; Hage, Boris; Franzen, Alexander; Lastzka, Nico; Goßler, Stefan; Danzmann, Karsten et al. (2008). "Observation of Squeezed Light with 10-dB Quantum-Noise Reduction". Phys. Rev. Lett. 100 (3): 033602. Bibcode 2008PhRvL.100c3602V. doi:10.1103/PhysRevLett.100.033602. 
  7. ^ M. D. Reid and P. D. Drummond (1988). "Quantum Correlations of Phase in Nondegenerate Parametric Oscillation". Phys. Rev. Lett. 60 (26): 2731. Bibcode 1988PhRvL..60.2731R. doi:10.1103/PhysRevLett.60.2731. 
  8. ^ Z. Y. Ou, S. F. Pereira, H. J. Kimble, and K. C. Peng (1992). "Realization of the Einstein-Podolsky-Rosen paradox for continuous variables". Phys. Rev. Lett. 68 (25): 3663. Bibcode 1992PhRvL..68.3663O. doi:10.1103/PhysRevLett.68.3663. 
  9. ^ A. S. Villar, L. S. Cruz, K. N. Cassemiro, M. Martinelli, and P. Nussenzveig (2005). "Generation of Bright Two-Color Continuous Variable Entanglement". Phys. Rev. Lett. 95 (24): 243603. arXiv:quant-ph/0506139. Bibcode 2005PhRvL..95x3603V. doi:10.1103/PhysRevLett.95.243603. 
  10. ^ K. Kasai, J.G. Gao, and C. Fabre (1997). Europhys. Lett. 40: 25. Bibcode 1997EL.....40...25K. doi:10.1209/epl/i1997-00418-8. 
  11. ^ A. S. Villar, M. Martinelli, C Fabre, and P. Nussenzveig (2006). "Direct Production of Tripartite Pump-Signal-Idler Entanglement in the Above-Threshold Optical Parametric Oscillator". Phys. Rev. Lett. 97 (14): 140504. arXiv:quant-ph/0610062. Bibcode 2006PhRvL..97n0504V. doi:10.1103/PhysRevLett.97.140504. 
  12. ^ M. Martinelli, N. Treps, S. Ducci, S. Gigan, A. Maître, and C. Fabre (2003). "Experimental study of the spatial distribution of quantum correlations in a confocal optical parametric oscillator". Phys. Rev. A 67 (2): 023808. arXiv:quant-ph/0210023. Bibcode 2003PhRvA..67b3808M. doi:10.1103/PhysRevA.67.023808. 
  13. ^ T. Tanimura, D. Akamatsu, Y. Yokoi, A. Furusawa, M. Kozuma (2006). "Generation of a squeezed vacuum resonant on a rubidium D1 line with periodically poled KTiOPO4". Opt. Lett. 31 (15): 2344. arXiv:quant-ph/0603214. Bibcode 2006OptL...31.2344T. doi:10.1364/OL.31.002344. PMID 16832480. 

External links

Articles on OPOs

  • [1] Encyclopedia of Laser Physics and Technology

Companies commercialising OPOs

  • [2] Radiantis

See also


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Parametric oscillator — A parametric oscillator is a simple harmonic oscillator whose parameters (its resonance frequency omega and damping eta) vary in time in a defined wayAnother intuitive way of understanding a parametric oscillator is as follows: a parametric… …   Wikipedia

  • Optical parametric amplifier — An optical parametric amplifier, abbreviated OPA, is a laser light source that emits light of variable wavelengths by an optical parametric amplification process. Contents 1 Optical parametric generation (OPG) 2 Optical parametric amplification… …   Wikipedia

  • Harmonic oscillator — This article is about the harmonic oscillator in classical mechanics. For its uses in quantum mechanics, see quantum harmonic oscillator. Classical mechanics …   Wikipedia

  • OPO — Optical Parametric Oscillator (Academic & Science » Physics) ** Porto, Portugal (Regional » Airport Codes) * Old Post Office (Governmental » FBI Files) * Owen, Patterson, & Owen (Business » Firms) * Owen, Patterson, & Owen (Community » Law) *… …   Abbreviations dictionary

  • OPO — • Optical Parametric Oscillator ( > IEEE Standard Dictionary ) • Porto, Portugal internationale Flughafen Kennung …   Acronyms

  • Potassium titanyl phosphate — (KTiOPO4) or KTP is a nonlinear optical material which is commonly used for frequency doubling diode pumped solid state lasers such as and other neodymium doped lasers. The material has a relatively high optical damage threshold ( 15 J/cm²), a… …   Wikipedia

  • Ekspla — Infobox Company company name = EKSPLA company company type = Joint stock company foundation = 1983 in Vilnius, flagicon|Lithuania Lithuania location = Vilnius,flagicon|Lithuania Lithuania key people = CEO Kestutis Jasiunas industry = Scientific… …   Wikipedia

  • Laser acronyms — Here, is a list of acronyms used in laser physics, applications and technology.A*AOM – acousto optic modulator *APD – avalanche photodiode *APM – additive pulse mode locking *ASE – amplified spontaneous emission *AWG – arrayed waveguide… …   Wikipedia

  • Modelocking — Mode locking is a technique in optics by which a laser can be made to produce pulses of light of extremely short duration, on the order of picoseconds (10 12s) or femtoseconds (10 15s).The basis of the technique is to induce a fixed phase… …   Wikipedia

  • Lithium niobate — (LithiumNiobiumOxygen|3) is a compound of niobium, lithium, and oxygen. It is a colorless solid that is insoluble in water. Its melting point is 1257 °C and its density is 4.65 g/cm³. Its CAS number is CASREF|CAS=12031 63 9.Lithium niobate… …   Wikipedia


Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.